How do you find a center line for a fabricated panel?

Fire Protection
Rough-In

A panel fabricated around a standpipe is cut in a shop from numbers taken on site, so a height and an offset have to be right the first time or the panel comes back. The T1R Range gives both with the green laser confirming alignment on each shot, and the readings stay on the device to export to the shop. What gets cut matches what was standing in front of you.

How the shop gets the right numbers

Height off the ground and the offset
Green laser confirms each alignment
T1R holds both readings on the device
Exports straight to the shop
The panel is cut to what was measured

Shop Now Shop All

Put the laser on it instead of eyeballing. To fabricate a panel around this standpipe, the T1R Range gives the height off the ground at 48 inches and the offset at 20 and 5/16, with the green laser confirming alignment on each shot. Both readings stay on the device and export straight to the shop.