Measuring cabinet parts and labelling them in one pass

Cabinets & Millwork
Material Tracking
BOLDR

Shop-built carcasses leave the bench as a stack of look-alike boxes, and the thing that goes wrong is remembering which one belongs in which room. Each reading saves into BOLDR as it is taken and the P1L Tagger prints the tag beside the work, so a box is labelled before it is carried anywhere. Nothing goes onto masking tape and nothing gets matched up by eye at the far end.

Tag it before it moves

Shop boxes all look alike once stacked
Readings save into BOLDR as you take them
P1L Tagger prints right beside the work
The box is labelled before it is carried
No masking tape and no guessing later

Shop Now Shop All

Site-built cabinet carcasses stand open on a floor with wiring coiled inside one of them. A phone showing the BOLDR measurement list and a P1L Tagger printer sit together on the edge of a box, printed labels already curling off the roll. Readings are taken and tagged in the same motion, with nothing written down in between.