One tool for tight inside corners and a long hallway run

Finish Carpentry
Trim & Molding
Choosing a Tool

Trim work swings between two extremes in the same afternoon: a return that has to be picked up inside a corner to the sixteenth, and a hallway run too long to pull a blade down without a helper on the far end. The T1R Range covers both, reading as a tape into the corner and switching to laser for the run. Carrying one tool rather than two is also what keeps both sets of figures in the same saved list.

Which mode for which run

Inside returns to the sixteenth
Hall runs too long to pull a blade
T1R reads as a tape into the corner
Switch to laser for the long run
Both figures in one T1R Range list

Shop Now Shop All

An inside dimension is taken in a finished interior with the tool hooked into a corner against the wall and base trim. The tool is then switched to laser and a green line runs away down a long hallway over a concrete floor, the display stepping through readings in the eighties. Both are taken without the tool being set down or swapped.