Templating a vanity countertop to order

Countertops
Cabinets & Millwork
Remodeling
BOLDR

A countertop is cut once, off site, from numbers you hand over, so the template has to carry the width, the depth, the run to the wall and whether that wall is square. The T1R Range takes each of those and drops it straight onto the diagram in BOLDR, so the fabricator receives a dimensioned drawing rather than a list somebody has to interpret. The middle reading is what catches a wall that is out.

What the template has to carry

Cut once, off site, from your numbers
Width, depth, run and a squareness check
T1R drops each onto the diagram
Middle reading catches an out-of-square wall
The T1R Range sends a drawing, not a list

Shop Now Shop All

A bathroom vanity carcass is measured with plumbing stub-outs already in the wall and a tablet propped alongside showing a countertop diagram in BOLDR. The laser is used for the length and run to the wall, and a middle measurement is taken to check the wall is square, reading twenty and a half. Each figure lands on the diagram before the next is taken.