Does a digital tape measure give the same reading twice?

Layout
Accuracy

Accuracy and repeatability are two different questions, and repeatability is the one that decides whether a run of parts fits. A tool that is dead on once and a sixteenth off the next time gives you a stack of pieces no two of which match. The T1M Utility reads the printed pattern on the blade rather than counting up from a hook, so the same pull on the same board returns the same number. That is what makes a saved cut list worth sending to the saw.

What repeatability means on the job

Same pull returns the same number
T1M reads the pattern, not a hook count
Repeatability is what makes parts match
No adjustment between pulls
T1M cut lists stay trustworthy

Shop Now Shop All

The video takes the same measurement on the same board over and over, letting the blade retract and pulling it again each time, and the display comes back to the same figure on every pull. Nothing is adjusted between takes. It is a plain demonstration of the property nobody markets and everybody depends on.