Drilling a row of holes at even spacing

Metal & Extrusion
Layout
Accuracy

A run of anchors or fixings at fixed centres is a layout problem wearing a drilling costume, and measuring each one separately is where the spacing drifts. Incremental mode on the T1 Tomahawk advances the target by the same step every time and the laser puts the dot on the material, so you drill to a visible mark. Spacing stays true down the whole run.

Why repeat drilling drifts

Incremental mode advances by a fixed step
T1 laser puts the dot on the material
Drill to a visible mark, not a pencil dot
No measuring between each hole
Spacing stays true down the run

Shop Now Shop All

A run of holes at fixed centres is layout, not drilling. Incremental mode advances the target by the same step each time, and the laser puts the dot on the material where the next hole goes, so you drill to a visible mark instead of measuring, marking and punching each one separately.