Is a bent tape measure hook throwing off your cuts?

Maintenance & Repair
Accuracy

A hook bends the first time a tape hits a slab, and nothing about it looks wrong afterwards; the error just shows up in cuts that come back a sixteenth short. The REEKON Accuracy Block gives you a known reference to seat the blade against, so the hook is checked in seconds against a fixed standard rather than against another tape that may be wrong in the same direction.

How the hook gets checked

A dropped hook bends without looking bent
Accuracy Block is a fixed known reference
Seat the blade and read the half inch
Checked in seconds, not by feel
Beats comparing against another tape

Shop Now Shop All

A bent hook is one of the most common sources of tape measure error, and it stays invisible until the cuts come back wrong. The REEKON Accuracy Block checks it in seconds. Seat the blade in the slot and compare the half inch mark against the scale. Dead on zero means no play in the pull direction.