Going from a saved measurement straight to the saw stop

Cut Lists
Miter Saw
Bluetooth Transfer

The gap between measuring and cutting is where numbers get lost, because that is the only part of the process that runs on memory. A reading saved on the tape arrives at the M1 Caliber as a target on the stop, so the person cutting sets to a figure that came off the wall rather than one read out, written down and read again.

Closing the gap between the two

Reading saved at the wall
Arrives as a target on the M1 stop
The only step running on memory
No reading out and writing down
Two tools, one number

Shop Now Shop All

The gap between measuring and cutting is where numbers get lost. A reading saved on the tape arrives at the saw as a target on the stop, so the person cutting sets to a number that came off the wall rather than one that was read out, written down and read again.